1987 Williams 60x90 Hammermill Shredder

Year: 1987
SN: 17252

System includes the following:

• 45ft long infeed conveyor
• Williams 60x90 mill
• Undermill oscillator
• Walker stationary drum magnet
• (2) ferrous picking conveyors
• (1) nonferrous stacking conveyor
• (1) ferrous stacking conveyor
• (1) nonferrous takeaway conveyor
• (1) nonferrous conveyor with 32in magnet
• (1) ferrous takeaway conveyor
  • All conveyors have electric motors attached
• 185 lb hammers (Only run 20 hammers in the mill)
  • Extra hammers to go with it
• GE electric motor 575 horsepower, 510 rpm, 460 volts (has an 8ft drive shaft on it)
  • Shredder turns at 675 rpm; runs on a sheave system
• Hydraulic lube pump for bearings
• Hydraulic system that runs sheave system and rejection door
• Hydraulic system for pin puller and opening mill
• Motor controls
• Disconnect electrical panel box
• New grates recently installed in the mill
  • Used grates to go with it

Until this shredder is sold, it will be hooked up to power and can be demonstrated.

Selling as-is where-is.

Seller will rig and load on buyers trucks for an additional $10,000. This does not include the cost of the crane rental, only
the disassembly and loading.

Not included, but available for an additional $15,000:

• Cummins 16V diesel 1800 Hp with a 1300 Kw generator we use as a soft start before we switch over to the grid.