ZB Thor 1521 K Tracked Hammermill Shredder

Year: 2017
Model: Thor 1521 K
S/N: PY160142
Hours: 9,192

Overview:

• Went into production in 2018
• Caterpillar Tier 4 diesel engine produces 755 HP
• Tilting feed chute, 58 inches wide
• Single feed roll with hydraulic drive and hydraulic cylinder elevation
• Hammer weight 230 lbs
• Hammer swing diameter of 80 inches
• Hydraulic ejection gate for unshreddables
• Reinforced rubber belt discharge conveyor; 40 inches wide by 21 feet long, discharge height of 8.2 feet
• Assembled dimensions 52.5 feet long by 11.5 feet wide by 17.5 feet tall
• Capable of processing light aluminum scrap, aluminum bales, aluminum engines, light ferrous scrap, pre-shredder ferrous scrap, and white goods at a rate of approximately 10-17 tons per hour

Condition:

• Recently installed a new radiator at a cost of $15,000
• New discharge belt and drive motor
• Wear liners and rotor 70-75%
• The remote is working and will go with the machine
• Has been out of service since March 2024
• Comes with some new hardware, a couple of liner plates, and a pin puller
• A new set of hammers was installed prior to shut down

Transportation:

• Crane rental for disassembly will be the responsibility of the buyer
• Seller's crew is available for hire to reassemble the unit once delivered
• Unit weighs about 100 tons assembled and will require several flat bed and lowboy loads depending on final destination and route

Selling as-is where-is

Additional photos will be uploaded as they become available. Check back for updates.