Universal 74x104 Hammermill Shredder

• Feed chute
  • Approximately 102" wide by 28' long
  • Liners look to be in fair to good shape
  • Walls are approximately 48" tall
  • Feed roll cutouts made out of thick diamond plate
  • Overall dims: 32' long by 10' wide by 5'6" tall
• Shredder base
  • Some new/newer banana liners & other misc. liners in bins inside building on property
  • One small section in each wall is missing; was cut out and will need repair
  • Some bolts were cut out with a torch instead of being cut off and removed; will need repair
  • Box was cut in half for ease of shipping; has since been realigned and welded back together - steel tube added for support during the repair process
  • Overall dims: 18'6" long by 14'4" wide by 6'4" tall
• Front wall/anvil section
  • ​​​​​​​Some evidence of stress cracks; will need repair prior to use
  • Corner section repaired at some point
  • Overall dims: 114" wide by 48" long by 37" tall
• Shredder mid-section
  • ​​​​​​​Majority of liners still in place and one section of grates still in
    • ​​​​​​​Grates appear to be approximately 5" by 6" openings
  • Reject door hinge sections on each side appear to have been cut out by torch
  • Steel plate bolted/welded on top to help lift/load - welds breaking in some spots
  • Side wall liners are 6" thick
  • Grates and front wall liners held in place with pins bolted through each side wall
  • Appears to be in good shape overall
  • Overall dims: 13'6" long by 14'4" wide by 6'6" tall
• Shredder top section/bonnet
  • ​​​​​​​Half-dome shape
  • Unable to provide interior photos or provide liner information due to how it is sitting on the ground
  • Overall dims: 132" wide by 113" long by 74" tall
• Used spider rotor assembly with pins and bearings
  • ​​​​​​​Heavy wear on spider arms and caps; buildup work needed
  • Newell bearing set attached
  • Drive shaft coupler
  • Amsco caps on the end discs
  • No hammers included
  • Used pins show wear
  • Overall dims: 186" wide by 66" diameter by 66" tall
• Hydraulic power units for the DFR and shredder box opening cylinders, pin puller
• Pin puller
• Misc. wear parts (liners, spider rotor caps, etc.)
• Foundation drawings and blueprints
• Plant layout drawings
• Assembly drawings for inside shredder

Selling As Is Where Is

*Photos updated 11/9/23
Additional photos available upon request. Please call Dade Auctions at (419)930-9000.